RPS-400 series. 400W Reliable Green Medical Power Supply. Type. File Name:RPS-400-SPEC

Transcript

1 Ⅰ Ⅱ + + Ⅰ Ⅱ μ Type File Name:RPS-400-SPEC

2 SPECIFICATION MODEL RPS-400- RPS RPS RPS RPS RPS RPS OUTPUT INPUT DC VOLTAGE V 5V 8V 4V 7V 36V CURRENT 5CFM 33.3A 6.7A.3A 6.7A 4.9A.A Convection 0.8A 6.7A 3.9A 0.5A 9.3A 7A RATED POWER 5CFM Convection 399.6W 49.6W 400.5W 50.5W 40.4W 50.W 400.8W 5W 40.3W 5.W 403.W 5W RIPPLE & NOISE (max.) Note. 0mVp-p 0mVp-p 50mVp-p 50mVp-p 00mVp-p 00mVp-p VOLTAGE ADJ. RANGE(main output ).4~.6V 4.3~5.8V 7.~8.9V.8~5.V 5.6 ~ 8.4V 34. ~37.8V VOLTAGE TOLERANCE Note.3 ±3.0% ±3.0% ±3.0% ±.0% ±.0% ±.0% LINE REGULATION ±0.5% ±0.5% ±0.5% ±0.5% ±0.5% ±0.5% LOAD REGULATION ±.0% ±.0% ±.0% ±.0% ±.0% ±.0% SETUP, RISE TIME 000ms, 30ms/30VAC 500ms, 30ms/5VAC at full load HOLD UP TIME (Typ.) 6ms/30VAC 6ms/5VAC at full load VOLTAGE RANGE Note.4 80 ~ 64VAC 3 ~ 370VDC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR PF>0.94/30VAC PF>0.98/5VAC at full load EFFICIENCY (Typ.) 9.5% 9% 93% 93% 93.5% 94% AC CURRENT (Typ.) 4.A/5VAC.A/30VAC INRUSH CURRENT (Typ.) COLD START 35A/5VAC 70A/30VAC LEAKAGE CURRENT (max.) Note.5 Earth leakage current <60μ A/64VAC 50Hz, Touch current < 70μ A/64VAC OVERLOAD 05 ~ 35% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 48V 8.4A 5.3A 403.W 54.4W 00mVp-p 45.6 ~50.4V ±.0% ±0.5% ±.0% 94% PROTECTION OVER VOLTAGE 3. ~ 5.6V 6.5 ~ 9.5V 9.8 ~ 3.V 6.4 ~ 3.V Protection type : Shut down o/p voltage, re-power on to recover 9.7 ~ 35.V 39.6 ~ 46.8V 5.8 ~ 6.4V OVER TEMPERATURE 5V STANDBY FAN SUPPLY FUNCTION PS-ON INPUT SIGNAL Protection type : Shut down o/p voltage, recovers automatically after temperature goes down 5Vsb : 5V@0.6A without fan, A with fan 5CFM ; Tolerance ± %, ripple : 0mVp-p(max.) V@0.5A for driving fan ; Tolerance ± 0% Power on: PS-ON = "Hi" or " > ~ 5V" ; Power off: PS-ON = "Low" or " < 0 ~ 0.5V" ENVIRONMENT POWER GOOD / POWER FAIL WORKING TEMP. WORKING HUMIDITY STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION 500ms>PG>0ms ; The TTL signal goes high with 0ms to 500ms delay after power set up ; The TTL signal goes low at least ms before Vo below 90% of rated value -30 ~ +70 (Refer to "Derating Curve") 0 ~ 90% RH non-condensing -40 ~ +85, 0 ~ 95% RH non-condensing ± 0.03%/ (0 ~ 50 ) 0 ~ 500Hz, G 0min./cycle, 60min. each along X, Y, Z axes OPERATING ALTITUDE Note meters File Name:RPS-400-SPEC

3 SPECIFICATION SAFETY & EMC (Note 7) OTHERS SAFETY STANDARDS ISOLATION LEVEL WITHSTAND VOLTAGE ISOLATION RESISTANCE EMC EMISSION EMC IMMUNITY MTBF DIMENSION PACKING IEC6060-, TUV EN6060-, UL ANSI / AAMI ES6060- (3. version), CAN/CSA-C. No :4 - Edition 3 approved; Design refer to EN Primary-Secondary: xmopp, Primary-Earth:xMOPP, Secondary-Earth:xMOPP I/P-O/P:4KVAC I/P-FG:KVAC O/P-FG:.5KVAC I/P-O/P, I/P-FG:00M Ohms / 500VDC / 5 / 70% RH Parameter Conducted emission Radiated emission Harmonic current Voltage flicker Standard EN550 (CISPR) EN550 (CISPR) EN EN EN5504, EN6060--, EN604-3 Parameter Standard ESD EN RF field susceptibility EN EFT bursts EN Surge susceptibility EN Conducted susceptibility EN Magnetic field immunity EN Voltage dip, interruption 94.Khrs min. MIL-HDBK-7F (5 ) Type RPS-400 7*76.*35mm L*W*H P.W. Q TY 0.39Kg 36pcs EN RPS-400-C 30*86*43mm 0.5Kg 4pcs Test Level / Note Class B(Please see last page note) Class B(Please see last page note) Class A Test Level / Note 00% dip periods, 30% dip 5 periods, 00% interruptions 50 periods RPS-400-TF 30*86*66.5mm 0.58Kg 4pcs Level 4, 5KV air ; Level 4, 8KV contact Level 3, 0V/m Level 3, KV Level 4, 4KV/Line-FG ; KV/Line-Line Level 3, 0V Level 4, 30A/m RPS-400-SF 60*86*43mm 5*3*37inch. 5. *3. 39 *.69 inch 5*339*6inch *3. 39 *.69 inch 0.64Kg 4pcs G.W. 5Kg 3.Kg 4.9Kg 6.4Kg M MENT.03CUFT 0.77CUFT 0.86CUFT 0.9CUFT NOTE μ μ ClassⅠ ClassⅡ File Name:RPS-400-SPEC

4 Block Diagram PFC fosc : 90KHz PWM fosc : 00KHz I/P EMI FILTER RECTIFIERS & PFC POWER SWITCHING PWM CONTROL POWER SWITCHING +5Vsb DETECTION CIRCUIT RECTIFIERS & FILTER RECTIFIERS & FILTER RECTIFIERS & FILTER PG +5Vsb +V Fan Supply +S +V -V -S PG FG O.L.P. CONTROL DETECTION CIRCUIT O.V.P. PS/ON CONTROL PS-ON Output Derating vs Input Voltage LOAD (%) INPUT VOLTAGE (VAC) 60Hz File Name:RPS-400-SPEC

5 Derating Curve RPS-400 & RPS-400-C RPS-400-TF/SF 400 With 5CFM fan RPS-400-C:5VAC Converction 50 LOAD (W) { RPS-400:5VAC Converction RPS-400-C:30VAC Converction RPS-400:30VAC Converction { LOAD (W) (HORIZONTAL) (HORIZONTAL) AMBIENT TEMPERATURE ( ) AMBIENT TEMPERATURE ( ) Order No. RPS-400 RPS-400-C RPS-400-TF RPS-400-SF Products Convection 50W 50W Force Air 400W 400W 400W 400W File Name:RPS-400-SPEC

6 Mechanical Specification RPS-400 (PCB Type) Top View HS HS4 SVR CN ACL ACN F8A 50V FS HS HS3 FG 4-ψ 3.5 5cm Air flow direction FAN 5CFM 3.0 max. 35 CN 4 3 CN95 3 -V +V CN File Name:RPS-400-SPEC

7 RPS-400-C (Enclosed type) Case No. 47A Unit:mm 5cm Air flow direction Top View FAN 5CFM M3 L= R M3 L= Bottom View File Name:RPS-400-SPEC

8 RPS-400-TF (Enclosed type with fan on the top) Case No. 47A-D 47B-T Unit:mm M3 L= R.75 Top View Air flow direction M3 L= Bottom View File Name:RPS-400-SPEC

9 43 400W Reliable Green Medical Power Supply RPS-400-SF (Enclosed type with fan on the side) Case No. 48A Unit:mm Air flow direction Top View 4-M3 L= Bottom View File Name:RPS-400-SPEC

10 Mounting Instruction for -C/-TF/-SF Type Hole No. Recommended Screw Size MAX. Penetration Depth L Recommended mounting torque M3 mm 4~ 6Kgf-cm M3 4mm 4~ 6Kgf-cm Chassis of RPS-400-C/TF/SF Mounting Surface Mounting Screw L CONNECTION AC Input Connector (CN) : JST B3P-VH or equivalent Pin No. Assignment Mating Housing Terminal AC/N No Pin JST VHR JST SVH-T-P. or equivalent or equivalent 3 AC/L Function Connector(CN): TKP DHI-X or equivalent Pin No. 3 4 Assignment -S +S DC COM PG Mating Housing TKP DH or equivalent Terminal TKP or equivalent DC Output Connector (CN,CN3) Pin No. CN CN3 Assignment -V +V Output Terminals M3.5 Pan HD screw in positions Torque to 8 lbs-in(90cnm)max. Function Connector(CN95): TKP DHL-X or equivalent Pin No. Assignment Mating Housing Terminal 5Vsb TKP DH TKP,4 DC COM or equivalent or equivalent 3 PS-ON FAN Connector(CN) : TKP 88- or equivalent (Except for RPS-400-TF/SF) Pin No. Assignment DC COM +V Mating Housing TKP 50 or equivalent Terminal TKP 88 or equivalent Note:. When the input voltage is 30VAC, the PCB type (Blank-Type) model delivers EMI Class B for both conducted emission and radiated emission for the power supply; When the input voltage is 0VAC, the PCB type (Blank Type) model delivers EMI Class B for conducted emission and Class A for radiated emission for the power supply. It delivers Class A for conducted emission and radiated emission, when configured into Class Ⅱ (no FG) system.. The enclosed type (-C/TF/SF type) models are not suitable for configuration within a Class Ⅱ (without FG) system, but suggested within a Class Ⅰ(with FG) system. 3. Mounting Instruction for enclosed type. Installation Manual Please refer to : File Name:RPS-400-SPEC