LPFH-60 series. 60W Constant Voltage + Constant Current LED Driver IP67. File Name:LPFH-60-SPEC

Transcript

1 W Constant Voltage + Constant Current LED Driver LPFH- series IP67 ~ File Name:LPFH--SPEC

2 SPECIFICATION MODEL DC VOLTAGE CONSTANT CURRENT REGION Note.2 LPFH V 7.2 ~12V LPFH V 9 ~ 15V LPFH V 14.4 ~ 24V LPFH V 21.6 ~ 36V LPFH V 25.2 ~ 42V LPFH V 28.8 ~ 48V LPFH V 32.4 ~ 54V RATED CURRENT 5A 4A 2.5A 1.67A 1.43A 1.25A 1.12A OUTPUT RATED POWER Note.5 W W W.12W.06W W.48W RIPPLE & NOISE (max.) Note.3 150mVp-p 150mVp-p 150mVp-p 250mVp-p 250mVp-p 250mVp-p 350mVp-p VOLTAGE TOLERANCE Note.4 ±4.0% ±4.0% ±4.0% ±4.0% ±4.0% ±4.0% ±4.0% LINE REGULATION LOAD REGULATION ±2.0% ±1.5% SETUP, RISE TIME Note.6 500ms, ms / 347VAC 700ms, ms / 230VAC,277VAC INPUT PROTECTION VOLTAGE RANGE Note.5 FREQUENCY RANGE POWER FACTOR (Typ.) THD< 20%(@load 75%/347VAC) TOTAL HARMONIC DISTORTION (Please refer to TOTAL HARMONIC DISTORTION(THD) section) EFFICIENCY (Typ.) 86% 87% 89% 90% 90% 90% 90% AC CURRENT (Typ.) 0.4A / 230VAC,277VAC 0.32A / 347VAC INRUSH CURRENT (Typ.) COLD START A(twidth=550μ s measured at 50% Ipeak) at 347VAC; Per NEMA 410 MAX. No. of PSUs on 16A CIRCUIT BREAKER LEAKAGE CURRENT WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY SAFETY & EMC OTHERS NOTE HOLD UP TIME (Typ.) 10ms/230VAC,277VAC 10ms/347VAC OVER CURRENT SHORT CIRCUIT OVER VOLTAGE OVER TEMPERATURE MAX. CASE TEMP. TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE ISOLATION RESISTANCE EMC EMISSION EMC IMMUNITY MTBF DIMENSION PACKING W Constant Voltage + Constant Current LED Driver 200 ~ 0VAC 282 ~ 565VDC (Please refer to "STATIC CHARACTERISTIC" section) 47 ~ 63Hz PF 0.95/230VAC, 277VAC, PF 0.92/347VAC@full load (Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section) 7 units (circuit breaker of type B) / 12 units (circuit breaker of type C) at 347VAC <0.75mA / 347VAC 95 ~ 108% Hiccup mode, recovers automatically after fault condition is removed Hiccup mode, recovers automatically after fault condition is removed. Shut down o/p voltage, auto-recovery or re-power on to recovery Shut down o/p voltage, auto-recovery or re-power on to recovery 20 ~ 95% RH non-condensing - ~ +90, 10 ~ 95% RH ± 0.03%/ (0 ~ 50 ) 10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes UL8750 (type HL ), CSA C22.2 No (except for 48V, 54V), IP67 approved I/P-O/P:3.0KVAC I/P-O/P:M Ohms / 500VDC / 25 / 70% RH Compliance to FCC part 15 class B (@load %) Compliance to IEC60-4-2,4,5; light industry level (surge immunity : Line-Line:2KV) 162.5*43*32mm (L*W*H) 0.45Kg; 32pcs/15.4Kg/0.93CUFT LPFH- series 15 ~ 17V 17.5 ~ 21V 28 ~ 35V 41 ~ 49V 46 ~ 54V 54 ~ 63V 59 ~ 66V Tcase=- ~ +90 (Please refer to OUTPUT LOAD vs TEMPERATURE section) Tcase= K hrs min. Telcordia SR-332 (Bellcore) ; 343.9Khrs min. MIL-HDBK-217F (25 ) File Name:LPFH--SPEC

3 W Constant Voltage + Constant Current LED Driver LPFH- series Block Diagram PFC fosc : 50~120KHz PWM fosc : ~130KHz I/P EMI FILTER & RECTIFIERS PFC CIRCUIT POWER SWITCHING RECTIFIERS & FILTER O.L.P. Vo+ Vo- O.T.P. O.L.P. PWM & PFC CONTROL DETECTION CIRCUIT O.V.P. DRIVING METHODS OF LED MODULE This series is able to work in either Constant Current mode (a direct drive way) or Constant Voltage mode (usually through additional DC/DC driver) to drive the LEDs. In the constant current region, the highest voltage at the output of the driver depends on the configuration of the end systems. Vo(%) (min.) (A) Constant Voltage area (C) Hiccup Protection (B) Constant Current area Should there be any compatibility issues, please contact MEAN WELL. 50 Io(%) Typical output current normalized by rated current (%) File Name:LPFH--SPEC

4 W Constant Voltage + Constant Current LED Driver LPFH- series OUTPUT LOAD vs TEMPERATURE others 70 12V LOAD (%) 20 LOAD (%) (HORIZONTAL) AMBIENT TEMPERATURE,Ta ( ) Tcase ( ) (HORIZONTAL) STATIC CHARACTERISTIC POWER FACTOR (PF) CHARACTERISTIC Tcase at Constant Current Mode 90 1 LOAD (%) 70 PF VAC VAC 230VAC INPUT VOLTAGE (V) Hz De-rating is needed under low input voltage % % 70% % 90% % LOAD TOTAL HARMONIC DISTORTION (THD) 54V Model, Tcase at EFFICIENCY vs LOAD LPFH- series possess superior working efficiency that up to 90% can be reached in field applications. 54V Model, Tcase at 25% 95 THD 20% 15% 10% 5% 347VAC 277VAC 230VAC EFFICIENCY(%) VAC 277VAC 230VAC 65 0% 50% % 70% % 90% % LOAD 10% 20% 30% % 50% % 70% % 90% % LOAD File Name:LPFH--SPEC

5 W Constant Voltage + Constant Current LED Driver LPFH- series LIFE TIME 120 LIFETIME(Kh) Tc a s e ( ) File Name:LPFH--SPEC

6 W Constant Voltage + Constant Current LED Driver LPFH- series MECHANICAL SPECIFICATION Case No. LPF- Unit:mm 300± ±20 AC/N(White) AC/L(Black) 43 UL AWG 25 tc ψ ψ UL AWG Vo+(Red) Vo-(Black) tc : Max. Case Temperature INSTALLATION MANUAL Please refer to : File Name:LPFH--SPEC