-; Rev ; / EVALUATION KIT AVAILABLE µ µ PART ESD TEMP. RANGE - C to +5 C PPACKAGE SO TOP VIEW V EE V CC SENSE+ SENSE- R t R t R t R t MAX SENSE OUT SENSE+ SENSE- N.C. SHDN N.C. 3 5 R f R G R f 3 VDSL TRANSFORMER ISOLATION V EE 7 SO V CC Maxim Integrated Products
ABSOLUTE MAXIMUM RATINGS Supply Voltage (V CC to V EE )...V Voltage on Any Input to Ground...(V CC +.3V) to (V EE -.3V) Continuous Power Dissipation (T A = +7 C) SO (derate.33mw/ C above +7 C)...7mW Short-Circuit Duration...sec Operating Temperature Range ESD...- C to +5 C Storage Temperature Range...-5 C to + C Lead Temperature (soldering, sec)...+3 C Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. ELECTRICAL CHARACTERISTICS PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS DC SPECIFICATIONS Input Offset Voltage V OS V OUT = V, R L =.5 mv Input Offset Voltage Drift TCV OS V OUT = V, R L = 3 µv/ C Input Bias Current Input Offset Current I B I OS V OUT = V, R L =, V IN = -V OS V OUT = V, R L =, V IN = -V OS.3 µa µa Input Voltage Noise e n f = khz nv/ Hz f = MHz to MHz µv RMS Input Current Noise I n f = khz.7 pa/ Hz f = MHz to MHz 7 na RMS Input Capacitance C IN pf Differential Input Resistance MΩ Differential Input Voltage Range R L = -3. 3. V Common-Mode Input Voltage Range V CM R L = -.. V Gain A V -V V OUT +V, R L = 53Ω V/V Gain Error -V V OUT +V, R L = 53Ω.3 % Common-Mode Rejection CMR V CM = ±.V 7 db Power-Supply Rejection PSR V S = ±.5V to ±5.5V 7 db Quiescent Supply Current I SY V IN =, R L = 3 ma Shutdown Supply Current I SHDN V IN =, R L =. ma Single-ended, R L = 3. 3. Output Voltage Swing V OUT Differential, R L = 7. 7. Single-ended, R L =.5Ω.. V Differential, R L = 53Ω 5. 5. Output Current Drive I OUT V OUT = ±.V ma SHDN High Threshold SHDN Low Threshold SHDN Input Current V IH V IL I SHDN V SHDN.V 75 5 µa V SHDN V na.. V V
ELECTRICAL CHARACTERISTICS (continued) V CC = +5V, V EE = -5V, T A = T MIN to T MAX, unless otherwise noted. Typical values are at T A = +5 C.) PARAMETER AC SPECIFICATIONS -3dB Bandwidth Full-Power Bandwidth.dB Bandwidth Common-Mode Rejection Slew Rate Settling Time Differential Gain Differential Phase Spurious-Free Dynamic Range SYMBOL BW (-3dB) FPBW BW (.db) CMR SR t s DG DP SFDR V OUT.V RMS V OUT = Vp-p V OUT.V RMS CONDITIONS MIN TYP MAX f = MHz 7 3 5 Differential, -V V OUT +V V V OUT +V, R L = 5Ω, to.% A VCL = + to.% 3 f = 3.5MHz, R L = 5Ω. f = 3.5MHz, R L = 5Ω.3 f C = khz, V OUT =.Vp-p, R L = 33Ω singleended, R S = 5Ω, Figure f C = 5MHz, V OUT = Vp-p, R L = 5Ω differential, Figure 7 - -75 UNITS MHz MHz MHz db V/µs ns % degrees dbc 3
(V CC = +5V, V EE = -5V, R L = 5Ω, T A = +5 C, unless otherwise noted.) GAIN (db) 7 5 3 A VCL = + SMALL-SIGNAL GAIN k M M M G TOC- GAIN (db) 7 5 3 LARGE-SIGNAL GAIN k M M M - G CMR (db) 7 5 3 COMMON-MODE REJECTION k M M M TOC- SMALL-SIGNAL PULSE RESPONSE A VCL = + LARGE-SIGNAL PULSE RESPONSE A VCL = + IN IN VOLTAGE (mv/div) OUT VOLTAGE (5mV/div) OUT TIME (ns/div) TIME (ns/div) PSR (db) 7 5 3 POWER-SUPPLY REJECTION - OUTPUT IMPEDANCE (Ω), 3.3 3. 3. 3..3 CLOSED-LOOP OUTPUT IMPEDANCE - ISOLATION RESISTANCE (Ω) 35 3 5 5 5 ISOLATION RESISTANCE vs. CAPACITATIVE LOAD MAX/7-7 k M M M. k M M M 5 5 5 CAPACITATIVE LOAD (pf)
(V CC = +5V, V EE = -5V, R L = 5Ω, T A = +5 C, unless otherwise noted.) VOLTAGE NOISE (nv/ Hz) VOLTAGE NOISE k k k M - CURRENT NOISE (na/ Hz) CURRENT NOISE k k k M - HARMONIC DISTORTION (dbc) - - -3 - -5 - -7 - - - 5MHz HARMONIC DISTORTION vs. LOAD 3RD HARMONIC LOAD (Ω) ND HARMONIC MAX/7- HARMONIC DISTORTION (dbc) -3 - -5 - -7 - A VCL = +V V = Vp-p HARMONIC DISTORTION 3RD HARMONIC - ND HARMONIC - k M M M TOC-5 HARMONIC DISTORTION (dbc) - - -3 - -5 - -7 - - - 5MHz HARMONIC DISTORTION vs. OUTPUT SWING 3RD HARMONIC 3 OUTPUT SWING (Vp-p) ND HARMONIC MAX/7- OUTPUT SWING (Vp-p) OUTPUT SWING vs. LOAD RESISTANCE 5 5 5 LOAD (Ω) MAX/7-3 POWER-SUPPLY CURRENT vs. TEMPERATURE MAX/7-..5 INPUT OFFSET VOLTAGE vs. TEMPERATURE MAX/7-5 INPUT BIAS CURRENT vs. TEMPERATURE MAX/7- CURRENT (ma) VOLTAGE (mv)..5 CURRENT (µa) -.5 7-75 -5-5 5 5 75 5 TEMPERATURE ( C) -. -75-5 -5 5 5 75 5 TEMPERATURE ( C) -75-5 -5 5 5 75 5 TEMPERATURE ( C) 5
(V CC = +5V, V EE = -5V, R L = 5Ω, T A = +5 C, unless otherwise noted.) VOLTAGE (V)... 7. 7. 7.7 7. DIFFERENTIAL OUTPUT VOLTAGE SWING vs. TEMPERATURE -75-5 -5 5 5 75 5 TEMPERATURE ( C) MAX/7-7 GAIN (db) + + + + + + + + - SMALL-SIGNAL GAIN AND CAPACITIVE LOAD C L = 5pF C L = pf C L =5pF - k M M M - PHASE (deg) GAIN (%) DIFFERENTIAL GAIN AND PHASE. A.5 V = +V/V. -.5 -. -. IRE..3 A V = +V/V... -. IRE TOC-, 7 V EE 3, 5 N.C. SHDN, V CC 3 SENSE- SENSE+
R G 5Ω R T 5Ω 33Ω V MEASURE R G 5Ω R T 5Ω V MEASURE + 5Ω 33Ω V MEASURE -.k 7 7 7
e D B A A.mm.in. C L - DIM A A B C E e H L MIN.53...7.5.. INCHES.5 MAX.....57..5 MILLIMETERS MIN.35..35. 3. 5...7 MAX.75.5..5...7 E H Narrow SO SMALL-OUTLINE PACKAGE (.5 in.) DIM D D D PINS INCHES MIN..337.3 MAX.7.3.3 MILLIMETERS MIN..55. MAX 5..75. -A Maxim Integrated Products, San Gabriel Drive, Sunnyvale, CA () 737-7 Maxim Integrated Products is a registered trademark of Maxim Integrated Products.